(775) 980-1020Mon–Sun: 8 AM–9 PM
M&T Fernley Spray Foam Insulation
A crawl space has white vapor barrier covering the floor and silver insulation lining the walls beneath ducts and floor joists.

Insulation Contractor in Fallon, NV - Sealed Attics, Steadier Rooms

M&T Fernley Spray Foam Insulation is an insulation contractor working in Fallon, NV. We seal and insulate attics, walls and crawl spaces in houses around the city, and we spray foam the shops and outbuildings on bigger lots.

  • Licensed and insured.
  • Free on-site estimates.
  • Expect a reply within 1 business day.

Insulating Fallon houses, old and new

Fallon is a short drive east of our base in Fernley, and the work here covers a lot of ground. In one week we can be in an older house near downtown, a newer subdivision at the edge of the city and a shop out on acreage, much like the mix we see in Dayton.

The older houses usually still have whatever went in when they were built, often a few inches of fill that's settled flat, with open gaps around the hatch and the light fixtures. Newer houses tend to have more up there but run thin at the edges, which is backward, because the edges over the outside walls need it most. Shops are a different job again, since bare metal walls usually call for foam. So before I quote anything, I climb up and look, because what's already there decides whether we top up, seal first or start over.

What we do on Fallon properties

  • Attic insulation

    Hot upstairs rooms in Fallon houses usually mean too little in the attic. We measure what's there and blow in more, evenly out to the edges.

  • Insulation removal

    Older Fallon attics that got wet or hold droppings keep that problem under new insulation. Our insulation removal clears them so we start clean.

  • Attic air sealing

    Drafty rooms in houses here usually trace to open gaps around light fixtures, pipes and the attic hatch. We seal them first, since insulation won't stop a draft.

  • Crawl space insulation

    Fallon houses built over a crawl space often have cold floors when the insulation below has sagged or dropped. We fit it back snug against the floor above.

  • Spray foam insulation

    Many shops on Fallon acreage have bare metal walls that drip and run hot or cold. We spray foam the panels, sealing the seams as it insulates.

  • Commercial insulation

    Business owners in Fallon call when an office or storage building costs too much to heat and cool. I check how it's used before we choose the material.

What Fallon houses usually need first

The older the house, the more likely the attic has been patched, walked on and crushed over the years. On those, I look for an old roof leak, droppings and buried eave vents before anything else, because new insulation over any of that is money wasted. Sometimes the right call is to fix the leak now and insulate later, and I'll tell you so.

Newer houses bring a different question, because many of them run the ductwork through the attic. That's where the foam-or-fill choice matters. Spray foam costs more, but it seals air while it insulates, so it earns its price when the ducts live up there. Everywhere else, sealing the gaps and topping up with blown-in fill, loose insulation blown through a hose, usually does the job for less. What moves the price is the size of the attic, how easy it is to get into, whether old material has to come out and which material we use, and the schedule mostly turns on removal and how soon we can get in. Your estimate puts a figure on your own house.

Get a free on-site insulation estimate for your Fallon home

Send the form or call with your Fallon address and what's bothering you, whether it's a drafty room, cold floors or a high power bill, and we'll reply within one business day. I come out myself, look at the attic, walls or crawl space and write your estimate, with no obligation to go ahead. If you hire us, our own installers do the work and I check it before it's done.

Fallon insulation questions

Here's what Fallon homeowners ask before we climb into the attic. If your house doesn't fit these answers, call or send the form and ask about your own job.

Do I need a building permit for insulation in Fallon, NV?

Ask the City Building Department, because the work its permit form lists is HVAC, water heaters, minor electrical and plumbing, and re-roof and siding, and insulation isn't named. The department issues building permits inside Fallon city limits. When a job does need a permit, we pull it and line up the inspections for you.

Who issues building permits outside Fallon city limits in Churchill County?

The Churchill County Building Department permits and inspects residential and commercial construction in the unincorporated parts of the county. A Fallon mailing address doesn't always mean you're inside city limits, so I ask where your house falls at the estimate. If a permit is needed, we work with whichever office covers your address.

Does an insulation contractor in Fallon need a Nevada license?

For work under a city building permit, yes, because the city's permit form says construction has to be done by a contractor licensed in Nevada for that work. The one exception it makes is a homeowner doing the work as owner-builder. We're licensed and insured, and you're welcome to ask about it when I come out.

How much does insulation cost for a house in Fallon?

It comes down to your attic and what's already in it, so I give you a written number after I've looked, not over the phone. The biggest swing is whether old, soaked or dirty insulation has to come out first. A house that only needs its gaps sealed and a top-up costs far less than one that needs a full tear-out and new foam.

How long does attic insulation take, and do we have to leave the house?

With blown-in fill and air sealing, you can usually stay home while we work, and how long we're up there depends on the attic's size, how much sealing it needs and whether old material comes out first. Spray foam is different, because you, the kids and the pets need to be out while it goes on and until the re-entry time, the wait before anyone comes back inside, has passed. I'll give you both timings at the estimate so you can plan around them.

What is the best way to fix a hot room over the garage in a Fallon house?

Seal the air leaks first, then insulate, because that room usually loses to gaps and thin spots in its walls and floor, not just the attic above it. We check the short walls beside the sloped ceiling and the floor over the garage, seal what's open and fill what's missing. We keep the eave vents clear while we're at it, so the attic can still breathe.